Electrical Engineer

Electrical Engineer

- Addison, TX

This is an onsite position supporting our Engineering team and will be responsible for the electrical and FPGA design and development of prototype and production units covering an entire cycle from concept/detailed design to manufacturing release of products and systems.

Job Responsibilities
Carry out detailed electrical design work including analog, digital, FPGA design, schematic capture, PCB layout, testing and verification, & manufacturing release.
Responsible for performing design validation and testing, including highly accelerated life testing (HALT), environmental qualification testing (DO-160G), etc.
Produce and maintain technical documentation including HALT summaries, test procedures, qualification test reports, etc.
Take an electrical lead on specific projects following department processes and standards and ensure the design meets customer and functional requirements.
Conceive, research, and implement engineering design changes yielding improvements in manufacturability and robustness in coordination with sustaining engineering team.

Required Qualifications
Bachelor of Science degree in Electrical Engineering (BSEE)
Three (3) - ten (10) years of electrical and FPGA design experience
Experience with microprocessor and/or DSP-based designs
Experience with network/Ethernet design
Experience with hardware diagnostic tools including oscilloscopes, logic analyzers, spectrum analyzers, etc.
Ability to understand and apply functional and technical specifications, datasheets, hardware manuals, etc. to electrical designs
Ability to coordinate with the other discipline Engineers (ME & SE) within the department to produce multidisciplinary design solutions.
Requires minimal supervision and produces designs to specified deadlines.
Schematic Capture and PCB Layout: Experience with OrCAD Capture/Allegro PCB Designer or similar toolset (will be required to use OrCAD/Allegro)
FPGA/ASIC design experience (will be required to use Xilinx FPGAs and toolset)

Desired Qualifications
Familiarity with embedded software design (C, assembly, etc.)
Experience with RTCA DO-160G

#J-18808-Ljbffr